ADDONICS TECHNOLOGIES
Model: ZHDUESA
I. HDD Duplicator Overview
IV. Duplicating a drive
When the duplicator powers on, it initializes and goes through the
steps below
Note: Make sure that the capacity of the target hard disk is
equal or larger than the source hard disk.
Step 1
Connect the Source drive into the source eSATA port at the
back of the HDD Duplicator. Make sure that the source eSATA
drive is powered on.
Copy HDD copies data directly from the source hard disk to the
target hard disk.
Step 2
Connect the Target drive into the target eSATA port at the back
of the HDD Duplicator. Make sure that the target eSATA drive is
powered on.
Press ENT button to begin copy. The system will auto-detect the
hard disks and show the following info on the LCD.
II. Connecting the power cable and powering on
a. Connect the power cord provided from the wall outlet to the
back of the HDD Duplicator.
The LCD will show the following info during the copying process:
remaining time, completed percentage. The copy speed, capacity
and time will vary depending on the source hard disk. Once the
copying process is complete the LCD will display the following
results.
Power Switch
Power Connector
The complete user manual of the HDD Duplicator Panel can
found in the Driver Disk under User Guides or can be
downloaded from
b. A power switch is located at the back of the enclosure. Slide
the switch to the left to turn on the HDD duplicator.
III. The Duplicator Panel
There are four buttons and an LCD on the panel of HDD
Duplicator.
1 – LCD shows a function or a message.
2 – it is used to scroll up function menus.
3 – it is used to scroll down function menus.
4 – it is used to execute a function.
5 – it is used to cancel a function.
Technical Support
Contact Information
Phone:
Fax:
408-573-8580
408-573-8588
Email:
Internet:
TECHNICAL SUPPORT
Phone:
Hours:
Email:
408-453-6212
8:30 am - 6:00 pm PST
|