INSTALLATION AND OPERATION
INSTRUCTIONS
MODEL
LDT-3001
DIGITAL SURFACE TEMPERATURE
METER
When you determine the location for the unit, drill a 2 1/8" (54 mm) hole
in the dash. Slide the unit through the hole from the front of the dash.
Align it so that it's straight, then tighten the two screws with a phillips-
head screwdriver.
CAUTION!
To prevent damage to the unit, DO NOT use a pneumatic/power screw-
driver. Use a hand-held screwdriver and the torque should not exceed 7
in lbs. Also, when removing the unit, do not back the screws out of the
case. Damage to the faceplate will result. We recommend backing off
the screws one complete turn before attempting to remove the unit. If
further loosening of the screws is required, do so in half-rotation incre-
ments.
Place the bezel on the front of the unit and snap the bezel over the
faceplate. The unit is now ready for wiring.
POWER CONNECTIONS (see diagram on the next page)
The3001operatesfrom10-15VDC(12voltbattery). Thepowercablehas
three wires - red, black, and white. The red wire is the positive conductor.
Connect it to an accessory switch.
IMPORTANT!
Make certain the red wire is fused. If the boat manufacturer installed your
unit, check the wiring and locate the 3001’s fuse holder. It should have a
1 amp fuse installed. If you purchased the 3001 from a dealer, a fuse
holder with fuse is supplied. Follow the wiring diagram carefully.
The unit won’t be harmed if the power wires are connected backwards,
however it won’t work until the wires are properly attached.
The black wire in the power cable is the negative or ground conductor.
Connect it directly to the battery’s negative terminal or the boat’s ground
buss.
The white wire is attached to the display’s backlight. You can attach this
wire to the power switch, a separate switch, or the boat’s main lighting
switch.
2
SENSOR'S
RED
SENSOR'S
SHIELD
WIRE
Note:
Light and
Power
Switches
Are Not
Included.
WIRE
TO
LIGHT
SWITCH
TEMPERATURE
SENSOR
POWER
SWITCH
WHITE
1-AMP
FUSE
RED
BLACK
12 VOLT
BATTERY
SENSOR CONNECTIONS
Mount the temperature sensor in a location that allows contact with the
water at all times. The illustration below shows a typical location. Once
a suitable place is found, mount the sensor to the hull with two #8 stainless
steel screws. (not included) Route the sensor cable to the 3001. Do not
cut the cable if it is too long! Coil and store it out of the way.
Attach the sensor wires to the 3001 using the supplied screws and
washers. Make certain to attach the sensor’s wires to the 3001 according
to the diagram shown below. If the wires are reversed, no damage to the
unit will occur, but it won’t work properly. The 3001 is now ready for use.
Download from Www.Somanuals.com. 3All Manuals Search And Download.
OPERATION
To use the 3001, simply turn the power switch on. The 3001 will instantly
show the surface water temperature. This unit shows temperature in
degrees Fahrenheit, in tenths of a degree. If the temperature is above
99.9 degrees, a small arrow appears in the upper left corner of the display
appears. For example, if the display reads 01.4 and the arrow is also on,
then the water temperature is 101.4 degrees.
®
SURFACE TEMP
oF
LOWRANCE
LDT-3001
TEMPERATURE = 75.6 DEGREES FAHRENHEIT
®
SURFACE TEMP
oF
LOWRANCE
LDT-3001
TEMPERATURE = 102.4 DEGREES FAHRENHEIT
Download from Www.Somanuals.4com. All Manuals Search And Download.
LOWRANCE ELECTRONICS
FULL ONE-YEAR WARRANTY
“We", “our”, or “us” refers to LOWRANCE ELECTRONICS, INC., the manufacturer of this
product. “You” or “your” refers to the first person who purchases this product as a consumer
item for personal, family, or household use.
We warrant this product against defects or malfunctions in materials and workmanship, and
against failure to conform to this product’s written specifications, all for one year (1) from the
date of original purchase by you. WE MAKE NO OTHER EXPRESS WARRANTY OR
REPRESENTATION OF ANY KIND WHATSOEVER CONCERNING THIS PRODUCT. Your
remediesunderthiswarrantywillbeavailablesolongasyoucanshowinareasonablemanner
that any defect or malfunction in materials or workmanship, or any non-conformity with the
product’s written specifications, occurred within one year from the date of your original
purchase, whichmustbesubstantiatedbyadatedsalesreceiptorsalesslip. Anysuchdefect,
malfunction, or non-conformity which occurs within one year from your original purchase date
willeitherberepairedwithoutchargeorbereplacedwithanewproductidenticalorreasonably
equivalenttothisproduct,atouroption,withinareasonabletimeafterourreceiptoftheproduct.
If such defect, malfunction, or non-conformity remains after a reasonable number of attempts
torepairbyus, youmayelecttoobtainwithoutchargeareplacementoftheproductorarefund
for the product. THIS REPAIR, REPLACEMENT, OR REFUND (AS JUST DESCRIBED) IS
THE EXCLUSIVE REMEDY AVAILABLE TO YOU AGAINST US FOR ANY DEFECT,
MALFUNCTION, OR NON-CONFORMITY CONCERNING THE PRODUCT OR FOR ANY
LOSS OR DAMAGE RESULTING FROM ANY OTHER CAUSE WHATSOEVER. WE WILL
NOT UNDER ANY CIRCUMSTANCES BE LIABLE TO ANYONE FOR ANY SPECIAL,
CONSEQUENTIAL, INCIDENTAL, OR OTHER INDIRECT DAMAGE OF ANY KIND.
Some states do not allow the exclusion or limitation of incidental or consequential damages,
so the above limitations or exclusions may not apply to you.
This warranty does NOT apply in the following circumstances: (1) when the product has been
serviced or repaired by anyone other than us, (2) when the product has been connected,
installed, combined, altered, adjusted, or handled in a manner other than according to the
instructions furnished with the product, (3) when any serial number has been effaced, altered,
orremoved, or(4)whenanydefect, problem, loss, ordamagehasresultedfromanyaccident,
misuse,negligence,orcarelessness,orfromanyfailuretoprovidereasonableandnecessary
maintenance in accordance with the instructions of the owner’s manual for the product.
Wereservetherighttomakechangesorimprovementsinourproductsfromtimetotimewithout
incurring the obligation to install such improvements or changes on equipment or items
previouslymanufactured.
Thiswarrantygivesyouspecificlegalrightsandyoumayalsohaveotherrightswhichmayvary
from state to state.
REMINDER: You must retain the sales slip or sales receipt proving the date of your original
purchase in case warranty service is ever required.
Download from Www.Somanuals.com.5All Manuals Search And Download.
How to Obtain Service
(Canadian Customers Only)
We back your investment in quality products with quick, expert service and genuine Eagle
replacement parts. If you need service or repairs, contact the Lowrance Factory Customer
Service Department at the toll-freenumber listedbelow. Atechnician maybeabletosolvethe
problemandsaveyoutheinconvenienceofreturningyourunit.Youwillbeaskedforyourunit's
serial number.
800-324-1356
Canada Only. Monday through Friday 8:00 A.M. - 8:00 P.M. Central Time.
How to Obtain Service
(International Customers Only)
If you need service or repairs, contact the dealer in the country you purchased your unit.
WARRANTY REPAIR WILL BE HONORED ONLY IN THE COUNTRY
UNIT WAS PURCHASED.
Please follow the shipping instructions shown below on this page if you have to mail your unit
to the dealer. For proper testing, repair, and service, send a brief note with the product
describingtheproblem. Besuretoincludeyourname,returnshippingaddress,andadaytime
telephonenumber.
Shipping Information
When sending a product for repair, we recommend you do the following:
1. Always use the original shipping container and filler material the product was packed in
when shipping your product.
2 Alwaysinsuretheparcelagainstdamageorlossduringshipment.Eagledoesnotassume
responsiblity for goods lost or damaged in transit.
3. For proper testing, repair, and service, send a brief note with the product describing the
problem. Besuretoincludeyourname,returnshippingaddress,andadaytimetelephone
number.
Accessory Ordering Information
To order accessories such as power cables or transducers, please contact:
1. Your local marine dealer. Most quality dealers that handle marine electronic equipment
should be able to assist you with these items. Consult your local telephone directory for
listings.
2. Canadian customers only can write:
Lowrance/Eagle Canada, 919 Matheson Blvd., E. Mississauga, Ontario L4W2R7
or fax 416-629-3118
Download from Www.Somanuals.co6m. All Manuals Search And Download.
How to Obtain Service (U.S.A. Only)
We back your investment in quality products with quick, expert service and
genuine Lowrance® replacement parts. If you're in the United States and
you have questions, please contact the Factory Customer Service Depart-
ment using our toll-free number listed below. You must send the unit to the
factory for warranty service or repair. Please call the factory before
sending the unit. You will be asked for your unit's serial number. Use the
following toll-free number:
800-324-1356
Your unit is covered by a full one-year warranty. (See inside for complete
warranty details.) If your unit fails and the failure is not covered by the
original warranty, Lowrance has a flat-rate repair policy that covers your
unit and accessories packed with the unit at the factory. There is a 180-
day warranty on all non-warranty repairs from the factory, which is similar
totheoriginalwarranty, butisfor180daysratherthanoneyear. Forfurther
details, please call us at the above number.
Lowrance Electronics may find it necessary to change or end our shipping policies, regula-
tions, and special offers at any time. We reserve the right to do so without notice.
Accessory Ordering Information
To order accessories such as power cables or transducers, please contact:
1) Your local marine dealer. Most quality dealers that handle marine
electronic equipment should be able to assist you with these items.
Consult your local telephone directory for listings.
2) LEI Extras, Inc. P.O. Box 129 Catoosa, OK 74015-0129
or call
800-324-0045
(USA orders only.)
LOWRANCE ELECTRONICS, INC. 12000 E SKELLY DR TULSA OK 74128
LITHO IN US.A.
122898
988-0099-02
|