English Manual
English Manual
Introduction
2. By using the DOS command line under Windows
Please check the package contents before proceeding, you should
find the following items included.
Start a DOS Window and type the following commands:
Syntax:
arp –s <IP address> <MAC address>
ping <IP address>
1. The LINDY NetCam
2. Power supply unit
3. Mounting bracket
Example:
4. I/O Terminal block connector
5. This user manual
LINDY NetCam
6. CD-ROM containing driver, software and user manual
User Manual
English
Benutzerhandbuch
Deutsch
Description and Installation
The following elements can be found on the front of the camera: The
lens, the microphone and the status LED. On the back panel you can
find: the power connector, the I/O terminal block, the Ethernet jack
and the label containing the serial number. To connect the camera
via a hub to an existing network, please use a standard 1:1 patch
cable, to connect it directly to a PC, please use a crossover patch
cable. If you wish to connect any external components (e.g. sensors/
alarms) then please refer to user manual on the CD-ROM. You can
now proceed to the installation and applying power to the LINDY
NetCam.
Setting the IP Address for the Camera
Please record the serial number from the label on the unit. This serial
number is the MAC address for the camera, for example
0002D11000520 = 00-02-D1-10-00-52. There are two ways to assign
an IP address to this MAC address.
Type the arp command and press ‘enter’
Type the ping command and press ‘enter’
1. By using the ‘Installer.exe’ software on the CD-ROM
If you see the reply message, the unit has been installed
successfully
Run the ‘Installer.exe’ first, then power on the unit.
Viewing the Camera via a Web browser
Click on the serial
number that
corresponds to your
Type the IP address that you’ve assigned. The required password is the
serial number (mind upper and lower cases), the login name is ‘root’
camera
Assign a free IP address
If you want to fix the
IP address of the unit,
check the option ‘Use
this IP whenever the
system boots’
LINDY No. 32444
Click ‘Set IP Address’ to start the installation process
© LINDY ELECTRONICS LIMITED & LINDY-ELEKTRONIK GMBH
-
FIRST EDITION (Feb-2003)
Click on the ’Configuration’ button for further adjustments
|