LENNOX HEARTH PRODUCTS
KITS AND ACCESSORIES
Cat. No.
H1538
H1539
H1540
H3435
Model
Description
775,175M REV. B
12/2005
TK3-36BL
TK3-36PB
TK3-36BS
TK3-33BL
TK3-33PB
TK3-33BS
3-pc. Black Trim Kit, MPE-36R,
3-pc. Brass Trim Kit, MPE-36R
3-pc. Stainless Trim Kit, MPE-36R
3-pc. Black Trim Kit, MPE-33R
3-pc. Brass Trim Kit, MPE-33R
3-pc. Stainless Trim Kit, MPE-33R
H3436
H1932
INSTALLATION INSTRUCTIONS FOR TRIM KITS
FOR USE WITH MODELS MPE-33R AND MPE-36R ELECTRIC FIREPLACE
* KIT CONTENTS:
1 ea. Top Panel
1 ea. Left Side Panel
1 ea. Right Side Panel
6 ea. Magnets
* Note: Trim Kits with Brass and Stainless Finishes also include:
~8”
1 ea. Left Side Channel
1 ea. Right Side Channel
1 ea. Top Channel
Double-sided tape on panels
(If the kit you purchased includes channels and double-sided tape, they
should be used)
Figure 2
Top Panel
Step 2.
*Top Channel
ꢀ
Brass and Stainless Trim Kits - Proceed to Step 3.
Black Trim Kits - Proceed to Step 4.
ꢀ
Right Panel
*Side Channels
Step 3. Place the side channels over the magnets (See Figure 3 ).
Ensure that the two side channels are flush with the bottom of the
fireplace. The wider side of the side channel should be on the front of
the fireplace face after installation.
Left Panel
Magnets
Figure 1
CAUTION: CAREFULLY SEPARATE THE MAGNETS BY TWISTING
THEM APART. BE VERY CAREFUL WHEN HANDLING, BECAUSE
THE MAGNETS ARE VERY POWERFUL AND CAN SNAP TO-
GETHER UNEXPECTEDLY AND POSSIBLY PINCH THE SKIN OR
FRACTURE THE MAGNETS.
Side
Channel
Approximate
Magnet
Placement
TOOLS REQUIRED:
None
Ensure
Channel is
Flush with
Base
INSTALLATION INSTRUCTIONS:
This kit contains trim panels used to finish the gaps between the wall-
board or optional mantel and the fireplace, providing the appliance a fin-
ished built-in look.
Figure 3
ENSURE FIREPLACE IS COOL TO THE TOUCH BEFORE STARTING IN-
STALLATION OF THE TRIM KIT
Step 3. Peel off the backing on the double-sided tape on the backside
of each side trim panel (see Figure 4 ). Avoid touching the sticky
surface of the tape.
Step 1. Place 2 magnets on each side of the fireplace, placed at approxi-
mately 8” from the top and 8” from the base. See Figure 2.
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
Page 1 of 2
|